Deckote is a semi-industrial hard wearing acrylic system that has been especially formulated for use by homeowners, contractors and painters on sundecks, porches, balconies, boat decks, steps and concrete areas.

 Created in the 1970's by Dicker Martens Paint Co., a division of Consolidated Coatings Corp., Deckote was the first acrylic-based sun deck coating developed.

 The benefits of this system quickly became renowned and today Deckote is still setting the industry standards for quality and durability.

 Materials required: 

  • Roller Tray 
  • Short Pile Paint Roller 
  • Paint Brush 
  • Scissors 
  • Deckote System

Deckote's long term experience and quality is the basis of it's three year guarantee on new plywood and plank decks.
 

Being an acrylic and containing no oils, DECKOTE breathes. Under a microscope DECKOTE looks like a layer of salmon eggs. Between the contact points of the beads is a microscopic pinhole which allows moisture vapour to escape, but will not allow the rain to come in. This greatly lessens the danger of blistering, peeling or cracking on wood and masonary.

 HOW TO DO IT

The Deckote System
  1. Deckote Crack Filler 
  2. Deckote Fibra Tape 
  3. Deckote Primer 
  4. Deckote Normal Base Coat 
  5. Deckote Skid Resistant Base Coat 
  6. Deckote Color Coat

The color coat has a choice of 5 colors: Rustic Green, Slate, Charcoal, Cedar and Cottage Brown.

 The Primer comes in both * and 1 gallon containers. Base and Color coats are packed in 1 and 3 gallon containers.

 NEW PLYWOOD

  1. Fill cracks 
  2. Tape joints and flashings 
  3. Prime coat deck 
  4. Base coat deck 
  5. Color coat deck

PREVIOUSLY PAINTED PLYWOOD

  1. Remove loose material 
  2. Sand glossy areas and wash with TSP solution, then rinse with tap water 
  3. Prime coat exposed wood 
  4. Base coat primed areas* 
  5. Color coat deck

*If a skid resistant finish is desired use skid resistant base coat over entire deck.

 NEW PLANK DECK

  1. Fill cracks 
  2. Prime coat planks 
  3. Base coat planks 
  4. Color coat planks

PREVIOUSLY PAINTED PLANK DECK

  1. Remove loose material 
  2. Sand glossy areas and wash with TSP solution, then rinse with tap water 
  3. Prime coat exposed wood 
  4. Base coat primed areas* 
  5. Color coat planks

*If a skid resistant finish is desired use skid resistant base coat over entire area.

DECKOTE SAFE-T-TRED 3 YEAR WARRANTY

For exterior grade plywood and planking

Consolidated Coatings Corporation guarantees the satisfactory performance of DECKOTE for three years from the date of purchase when applied according to manufacturers instructions. If this product fails to perform when applied as specified, our obligation is limited, upon proof of purchase, to supply enough additional DECKOTE to correct the condition or refunding the purchase price. Excluded from this warranty is any responsibility for consequential damages, any previously coated surfaces, any situation where an inferior substrate was used or failure due to structural problems. Implied warranties of merchantability and fitness for a particular purpose, and other implied warranties in law or equity, are limited in duration to three years.

NEW CONCRETE

  1. If under 6 months old and smooth wash with diluted muriatic acid to etch and neutralize. Rinse with tap water. Let dry. 
  2. Apply color coat.

PREVIOUSLY PAINTED CONCRETE

  1. Remove loose material 
  2. Sand glossy areas and wash with TSP solution then rinse with tap water. Let dry 
  3. Apply color coat.

Easy clean up with soap and water

DO's 
  1. Prepare the surface properly. 
  2. Apply DECKOTE at recommended spreading rate. 
  3. Allow 2-3 hours drying time between coats. 
  4. Make sure the temperature is going to be over 10degrees C for at least 4 hours after you have finished.
 DON'TS
  1. Start if the weather looks questionable 
  2. Apply when temperature in Below 10 degrees C 
  3. Thin The Product 
  4. Apply over loose paint, dirt or oily surfaces. 
  5. Put heavy furniture objects on the completed deck until coating has cured for 6 days. 
  6. Apply in the direct sun.

ENJOY YOUR FINISHED DECK FOR YEARS TO COME

 

CONSOLIDATED COATINGS
7651 Vantage Way, Tillbury Industrial Park
Delta BC Canada V4G 1A6

(604) 946-7626
Toll Free 1-800-663-5690

http://www.consolidatedcoatings.com

For information on our WOODPAL family of exterior restoration products click on the WOODPAL image.